Grizzly G0776, Руководство пользователя

Страница: 61 / 132

Model G0776 (Mfd. Since 7/14)
-59-
When the coolant pump is turned ON, fluid is
delivered through the nozzle attached to the car-
riage.
To use coolant system on your lathe:
1. Make sure coolant tank is properly serviced
and filled with appropriate fluid, and that you
are wearing necessary personal protection
equipment.
2. Position coolant nozzle for your operation.
3. Use coolant pump switch on control panel to
turn pump
ON.
4. Adjust flow of coolant at nozzle.
Important: Promptly clean any splashed fluid
from the floor to avoid a slipping hazard.
Coolant System
Figure 91. Coolant selection table.
Workpiece Dry
Water
Soluble Oil
Synthetic
Fluids
Sulferized Oil Mineral Oil
Aluminum X X
Brass X X X
Bronze X X X X
Cast Iron X
Low Carbon Steel X X
Alloy Metals X X X X
Stainless Steel X X X X
General Note: Cutting fluids are used for heavy-duty lathe operations and production turning. Oil-water emulsions and synthetic
cutting fluids are the most common for typical lathe operations. Sulferized oils often are used for threading. For small projects,
spot lubrications can be done with an oil can or brush, or omitted completely.
Running the pump without adequate fluid in
the coolant tank may permanently damage
it, which will not be covered under warranty.
BIOLOGICAL & POISON
HAZARD!
Use the correct person-
al protection equipment
when handling coolant.
Follow federal, state,
and fluid manufacturer
requirements for proper
disposal.
Always use high quality coolant and follow the
manufacturer's instructions for diluting. The quick
reference table shown in
Figure 91 can help you
select the appropriate fluid.
Refer to
Coolant System Service on Page 71
for detailed instructions on how to add or change
fluid. Check the coolant regularly and promptly
change it when it becomes overly dirty or rancid,
or as recommended by the fluid manufacturer.
Figure 90. Cutting fluid system controls.
Nozzle
Pump and Tank
Cutting Fluid
Pump
Switch