Grizzly G0764, Руководство пользователя, Страница: 39 / 124

Model G0764 (Mfd. Since 02/14)
-37-
Dust Collection
Figure 59. 5" dust hose attached to dust port.
To connect dust collection hoses:
1. Fit 5" dust hose over dust port on rear side of
cabinet, as shown in
Figure 59, and secure
with hose clamp.
Minimum CFM at 5" Dust Port: 615 CFM
Minimum CFM at 2
1
⁄
2
" Dust Port: 150 CFM
Do not confuse this CFM recommendation with
the rating of the dust collector. To determine the
CFM at the dust port, you must consider these
variables: (1) CFM rating of the dust collector,
(2) hose type and length between the dust col-
lector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines
throughout the system. Explaining how to cal-
culate these variables is beyond the scope of
this manual. Consult an expert or purchase a
good dust collection "how-to" book.
This machine creates substantial amounts
of dust during operation. Breathing air-
borne dust on a regular basis can result in
permanent respiratory illness. Reduce your
risk by wearing a respirator and capturing
the dust with a dust collection system.
2. Fit 2
1
⁄
2
" dust hose over dust port on blade
guard, as shown in Figure 60, then secure it
in place with a hose clamp.
Important: Secure 2
1
⁄
2
" dust hose to upper
guard arm (e.g., with cable tie) so that it will
not become entangled with workpiece or
blade during operations.
3. Connect 5" and 2
1
⁄
2
" dust hoses to a Y-fitting,
then attach it to a single dust collection
branch line.
4. Tug on dust hoses to make sure they do not
come off. A tight fit is necessary for proper
performance.
Figure 60. 2
1
⁄
2
" dust hose attached to blade
guard.
Hose
Clamp
Cable Tie