Grizzly G0758, Руководство пользователя

Страница: 26 / 52

-24-
Model G0758 (Mfd. Since 2/14)
table travel
the table travels in two directions and is con-
trolled by handwheels, as illustrated in
figure 23:
• X-axis (longitudinal)
• y-axis (cross)
X-Axis or Longitudinal Travel
(Left & Right)
Y-Axis or
Cross Travel
(In & Out)
figure 23. possible directions of table travel.
Graduated Dials
the handwheels have graduated dials that are
used to determine table movement in 0.001" incre-
ments, with one full revolution equalling 0.100".
rotate graduated dial to a relative starting point
(see
figure 24).
figure 24. graduated dial location.
graduated dial
X-axis handwheel
tool Needed Qty
hex Wrench 5mm .............................................. 1
to use X-axis handwheel:
1. loosen both X-axis table locks shown in
figure 25.
Note: To readjust positioning of table locks,
pull out and rotate.
2. position table stops along front of table to
restrict table travel.
3. adjust X-axis graduated dial to zero, then use
handwheel to move table.
y-axis handwheel
the saddle does not have limit stops. to move
the table along the y-axis, loosen the y-axis
table locks shown in
figure 25, then use the
handwheel in front of the table in the same man-
ner as the X-axis handwheel.
figure 25. X- and y-axis table travel locks.
X-axis
table locks
y-axis
table locks
table stops