Grizzly G0754, Руководство пользователя, Страница: 24 / 48

-22-
Model G0754 (Mfg. Since 1/13)
X-Axis Handwheel
Tool Needed Qty
hex Wrench 5mm .............................................. 1
To use the X-axis handwheel:
1. Loosen the X-axis table locks shown in
Figure 17.
Note: When tightened, table locks increase
table rigidity.
2. position the limit stops along the front of the
table to restrict table travel.
3. Adjust the X-axis graduated dial to zero, then
use the handwheel to move the table.
Y-Axis Handwheel
the saddle does not have limit stops. to move
the table along the y-axis, loosen the y-axis table
lock shown in
Figure 17, then use the handwheel
in front of the table in the same manner as the
X-axis handwheel.
X-Axis Power Feed
use Figures 18–19 and the following descriptions
to become familiar with the power feed controls.
Note: The power feed must be connected to an
independent, grounded 110V power supply to
operate.
Figure 18. X-axis power feed controls.
A
B
F
e
d
C
Figure 19. Limit switch and limit stops.
g
h
A. ON/OFF Light. Lights when the unit is turned
ON.
b. Direction Lever. Controls the direction of
powered table travel.
c. Rapid Switch. When held down, moves the
table rapidly in the direction chosen.
D. Power Light. Lights when the unit is con-
nected to power.
E. Speed Dial. Controls the rate of power feed.
F. ON/OFF Switch. turns the power feed ON
and
OFF.
G. Limit Stops. restrict table movement in their
locked position along the front of the table.
H. Limit Switch. stops table movement when
either side plunger contacts a limit stop.
Figure 17. table locks and limit stops.
Limit stops
X-Axis
table Locks
y-Axis
table Lock