Grizzly G0727, Руководство пользователя

Страница: 22 / 48

-20-
Model G0727 (Mfg. Since 7/11)
Figure 16. X- and Y-axis graduated dials.
Figure 17. Z-axis graduated dial.
Vertical Head
Movement
When using the mill in the vertical configuration,
the head can be tilted 50° left or right. By moving
the ram, the spindle can be positioned a maxi-
mum of 12
7
⁄
8
" from the column (spindle centerline
to column).
Tool Needed Qty
Hex Wrench 5mm .............................................. 1
Tilting Vertical Head
1. DISCONNECT MILL FROM POWER!
2. Loosen the tilt locking cap screw shown in
Figure 18.
3. Manually adjust the head tilt to the correct
angle for the operation, then re-tighten the
locking cap screw.
Note: Use the scale shown in Figure 18 to
gauge the angle. For more accurate results,
use a precision protractor between the spin-
dle and the table.
Locks
The table is equipped with X- and Y-axis lock
levers (see
Figure 15) to prevent unexpected
movement along either axis when movement is
not required. This helps ensure close tolerances
and accurate milling results.
Graduated Dials
Each handwheel has a graduated dial for gauging
table movement along the related axis.
The X- and Y-axis graduated dials (see
Figure 16)
are in increments of 0.001"—with one full rotation
equal to 0.0625".
The Z-axis graduated dial is in increments of
0.0005"—with one full rotation equal to 0.03125"
(see
Figure 17).
To use the Z-axis graduated dial, multiply the
increment amount shown by the number on the
dial. For example, if the 50 increment mark is
aligned with the indicator mark, then multiply
0.0005" by 50, which equals 0.025"
Figure 15. X- and Y-axis locks.
X-Axis
Y-Axis
Figure 18. Vertical head tilt controls.
Locking
Cap Screw
Scale