Grizzly G0714, Руководство пользователя

Страница: 23 / 48

Model G0714 (Mfd. Since 05/22)
-21-
25. Install dust collector power cord in plastic
raceway and snap cover in place, as shown
in
Figure 22.
Figure 22. Dust collector power cord installation.
Cover
26. Plug dust collector into power supply recepta-
cle on rear of control box shown in
Figure 23.
27. Pour desired amount of media into cabinet
through front door. DO NOT overfill.
28. Allow silicone sealant to fully cure. Otherwise,
when machine is turned
ON and media blast-
ing begins, seal may be broken, causing
leakage.
29. Inspect all seals, hose clamps, glove clamps,
and window seals for loose fittings, cracks or
leaks. Correct as required.
Figure 23. Dust collector connected to power
supply.
Test Run
30. Verify that plastic dust sheet is affixed to
inside of cabinet viewing window and light
window. If blasting operations begin with-
out these dust sheets installed, media will
permanently etch window glass and require
replacement.
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting table in the
SERVICE section of this manual can help.
The Test Run consists of verifying the following: 1)
The lights and the dust collector motor power up
and run correctly, 2) the ON/OFF switches work,
and 3) the air regulator and system are functional.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.