Grizzly G0707, Руководство пользователя

Страница: 27 / 48

Model G0707 (Mfd. Since 01/21)
-25-
Note: If the gun or metering valve begins to
clog or becomes completely clogged during
use, cover the hole in the blast tip tightly, then
pull the gun trigger or push the foot valve. Air
pressure will be then diverted back through
the media suction piping and usually blow out
the clog.
If clogging still persists, it is likely that the
moisture or contamination ratio in the media
is too high, or there could be a loose fitting
or leak in a hose. Dry out the media, install a
moisture trap, screen or replace the media, or
check for a leaking hose.
Only use high quality DRY media. DO NOT
use regular sand, and recognize when media
has broken down and is too fine or loaded up
with contaminants to work properly. Worn-out
media and contaminants will cause caking
and clogging.
If clogging persists, refer to
Troubleshooting
on Page 30 for further solutions.
Figure 24. Canister plunger.
14. When media blasting is complete, disconnect
the cabinet from power and the air supply.
13. Every 20-30 minutes during cabinet use, push
the canister plunger in until it stops, then let
your thumb slide off of the button so the spring
slaps the plunger back against the canister
wall. This causes vibration that knocks off the
material which is caked onto the outside of the
filter (
Figure 24). Every five hours of cabinet
use, service the dust collector filter. Refer to
Maintenance on Page 29 for procedures.