g0665 slow speed Cold Cut saw
-15-
5.
Attach the work stop rod by threading it into
the hole in the side of the vise base, as
shown in
figure 12
.
Test Run
once the assembly is complete, test run your
machine to make sure it runs properly.
if, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting
on
Page 27
.
if you still cannot remedy a problem, contact our
tech support at (570) 546-9663 for assistance.
To test run the machine:
1.
Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Verify that there is oil in the machine. see
Step 7
of
Setup
on this page.
3.
Make sure all tools and objects used during
setup are cleared away from the machine.
4.
Connect the machine to the power source.
5.
turn the machine
ON
.
6.
listen to and watch for abnormal noises or
actions. the machine should run smoothly
with little or no vibration or rubbing noises.
— strange or unusual noises should be inves-
tigated and corrected before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.
7.
turn the machine
OFF
.
figure 12.
Work stop rod.
6.
slide the work stop onto the work stop rod
and secure it by tightening the cap screw
(
figure 13
).
figure 13.
Work stop secured.
Vise Base
Work stop rod
Work stop
Cap screw
7.
Verify that there is oil in the gearbox by tilting
the saw up and checking the sightglass.
—if no oil is seen in the sightglass, see
Gearbox Oil
on
Page 26
.
—if oil is seen in the sightglass, no further
action is required. Continue to
Test Run
.
