-14-
g0665 slow speed Cold Cut saw
Setup
setup consists of assembling the stand, mounting
the machine to the stand, and attaching the work
stop.
To assemble the machine:
1.
Attach the front panel to one of the side
panels with three M8-1.25 x 20 hex bolts and
nuts, as shown in
figure 9
.
3.
Attach the rear panel to the stand with the
remaining hex bolts and nuts.
Note:
If you plan to mount your machine
stand to the floor, do so now (see
Mounting
to Shop Floor
on
Page 13
), then return
to
Step 4
, below, to mount the machine to
the stand. Otherwise, continue with
Step 4
,
below.
figure 9.
Front and side panels.
2.
Attach the remaining side panel in the same
manner as
Step 1,
as shown in
figure 10
.
figure 10.
second side panel attached.
Front panel
side panel
side panel
4.
place the saw onto the stand and secure it
with the four M8-1.25 X 35 hex bolts (
figure
11
).
This machine is very
heavy. Get lifting help or
use power lifting equip-
ment such as a forklift to
place this machine onto
its stand.
figure 11.
Mounting saw onto stand.
saw Base
stand
hex Bolt
