g0648 Welding Fume Extractor
-25-
SECTION 6: MAINTENANCE
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person-
al injury.
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section. always
wear an oSha approved respirator when clean-
ing this machine.
Daily Check/Maintenance:
•
leaking seals or ducting.
•
Worn or damaged power cord.
•
Clean slag drawer screens.
•
Empty dust drawer.
•
inspect and correct for any other unsafe
condition.
Weekly Check/Maintenance:
.
•
Carefully wipe off any dust caked on the elec-
tronic eye lens (see
Figure 23
for location).
Monthly Check/Maintenance:
•
disconnect from power and vacuum and
wipe out any dust buildup from the inside of
the control box and filter cabinets. do not use
compressed air close to the filters or electri-
cal components.
•
use a dry rag and wipe all drive chains and
sprockets clean; then brush the chain links
with a thin coat of light machine oil. refer to
Figure 23
for locations.
Schedule
use a dry rag to wipe all drive chains and sprock-
ets clean; then brush the chain links with a thin
coat of light machine oil. refer to
Figure 23
for
locations.
Lubrication
Cleaning the Model g0648 is relatively easy. put
on an oSha approved respirator and vacuum
excess dust, and wipe off the remaining dust with
a damp cloth. do not use harsh detergents or sol-
vent on the cabinet, and never spray compressed
air close to filters or electrical components.
Cleaning
Figure 23
. lubrication locations.
Electric
Eye
oil drive
Chains
