Grizzly G0639, Руководство пользователя

Страница: 21 / 32

Model G0639 22-Ton Hydraulic Log Splitter
-19-
SECTION 4: MAINTENANCE
To reduce the risk of
accidental start-up inju-
ry, disconnect the spark
plug wire before perform-
ing adjustments or main-
tenance.
Follow the maintenance schedule below and refer
to any specific instructions given in this section.
Before each use:
• Make sure hydraulic oil and engine oil levels
are full.
• Make sure leaks, kinks, or abrasions do not
exist in hydraulic hoses or fuel lines.
• Inspect for loose or bent components.
• Inspect that safety features, and appropriate
guards are working and are in place.
Every 150 hours of use:
• Clean hydraulic tank vent cap ( Figure 22 )
with solvent, and let air dry, and reinstall.
As needed:
• Remove wheels and clean and relubricate
wheel bushings with multipurpose grease at
least every six months.
• Inspect for burnt-smelling, or tan-colored
water contaminated hydraulic fluid. If con-
taminated, replace tank breather, clean tank
filter/strainer, flush system, and replace fluid.
• Refer to the Briggs & Stratton engine manual
for general engine maintenance schedules.
Schedule
Checking/Adding
Hydraulic Fluid
To check the hydraulic fluid level:
1
. Position the log splitter on level ground,
lower the front landing leg, and lock the leg in
place.
2
. Wipe the vent cap with a clean rag and
remove the vent cap shown in Figure 22 .
Cleaning
For optimum performance from your log splitter,
clean it with a brush after every use and wipe it
down occasionally with a rag.
Figure 23 . Hydraulic fluid level.
Full is 1" from the Top
of Tank
Hydraulic
Fluid
Figure 22
. Vent cap location.
3 . Shine a flashlight down into the vent port
until you see hydraulic fluid. The fluid surface
should be 1" from the top of the hydraulic
tank as shown in
Figure 23
.
4
. Add hydraulic fluid as required.
Vent Cap