model g0631 (mfg. since 3/10)
-9-
Figure 2.
typical 5-15 plug and receptacle.
<gdjcY^c\Egdc\
8jggZci8Vggn^c\Egdc\h
5-15 PLUG
GROUNDED
5-15 RECEPTACLE
This machine MuST have a ground prong in
the plug to help ensure that it is grounded.
DO NOT remove ground prong from plug
to fit into a two-pronged outlet! if the plug
will not fit the outlet, have the proper outlet
installed by a qualified electrician.
Extension cords
We do not recommend using extension cords, but
if you find it absolutely necessary:
•
Use at least a 14 gauge cord that does not
exceed 50 feet in length!
•
the extension cord must have a ground wire
and plug pin.
•
A qualified electrician mUst size cords over
50 feet long to prevent motor damage.
SEcTiON 2: ciRcuiT REQuiREMENTS
power connection Device
this machine comes with a plug, similar to
Figure
2
, to connect the machine to power. this plug can
be used to connect the machine to one 30 Amp
circuit or two 15 Amp circuits.
110v Operation
Full Load Amperage Draw
this machine draws the following amps under
maximum load:
Combined Amp draw, Both motors ....... 24 Amps
Amp draw per motor ............................. 12 Amps
power Supply circuit Requirements
this machine can be connected to a 30 Amp cir-
cuit or two dedicated 15 Amp circuits, as stated
below.
the power supply circuit for your machine mUst
be grounded and rated for the amperage given
below. never replace a circuit breaker on an exist-
ing circuit with one of higher amperage without
consulting a qualified electrician to ensure compli-
ance with wiring codes.
if you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, con-
sult a qualified electrician.
minimum Circuit size (one Circuit) ......30 Amps
minimum Circuit size (two Circuits) .....15 Amps
Serious personal injury could occur if you
connect the machine to power before com-
pleting the setup process. DO NOT connect
the machine to the power until instructed
later in this manual.
Electrocution or fire could
result if machine is not
correctly grounded or
connected to the power
source. Get help if you
do not know what you are
doing.
