Grizzly G0623X, Руководство пользователя

Страница: 50 / 80

-48-
G0623X/G0623X3 10" Sliding Table Saw
Lubrication
Bearings: The bearings are sealed and pre-lubri-
cated and require no lubrication.
Trunnions:
Use multi-purpose grease in the trun-
nion grooves ( Figure 80 ) every 6–12 months,
depending on the frequency of use. To grease the
blade height trunnion, move the blade height all
the way down and smear a dab of grease into the
trunnion groove, behind the plate shown in
Figure
80 , then move the blade up all the way to spread
the grease.
To grease the blade tilt trunnions, move the slid-
ing table out of the way and open the blade guard.
Tilt the blade to 90°. From the front of the saw,
smear a dab of grease in the front of the trunnion
grooves on both sides. Now, tilt the blade to 45°
and reach inside the cabinet and smear a dab of
grease into the back of the trunnion grooves on
both sides. Tilt the blade back-and-forth to distrib-
ute the grease evenly.
Figure 79. Sliding table ways.
Sliding Table Way Steel Rod
Leadscrews:
Use multi-purpose grease on the
leadscrews ( Figure 80 ) every 6-12 months, at
the same time you lubricate the trunnions. Wipe
the leadscrews clean with a dry rag and brush a
light coat of new grease on them with a clean,
dry brush. Only grease the area of the leadscrew
between the stop nuts. Move the blade height and
tilt back-and-forth to distribute the grease evenly.
Sliding Table Ways: Spray/wipe on a light
machine oil (such as Boeshield shown on
Page
46 ) down the entire length of the steel rods
(
Figure 79
).
Figure 80. Lubrication locations (table removed for clarity).
Blade Height Trunnion
(Grease Behind This
Plate)
Leadscrews
Blade Tilt
Trunnions