G0530 Variable Speed Buffer
-3-
9. USE PROPER EXTENSION CORD
. Make
sure your extension cord is in good condi-
tion. Conductor size should be in accor-
dance with the chart below. The amper-
age rating should be listed on the motor
or control panel faceplate. An undersized
cord will cause a drop in line voltage result-
ing in loss of power and overheating. Your
extension cord must also contain a ground
wire and plug pin. Always repair or replace
extension cords if they become damaged.
Minimum Gauge for Extension Cords
10. WEAR PROPER APPAREL.
DO NOT
wear loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Non-slip footwear
is recommended. Wear protective hair cov-
ering to contain long hair.
11. ALWAYS USE A SAFETY FACE SHIELD.
Also use a respirator. Everyday eyeglasses
are NOT safety glasses, and paper dust
masks are not respirators.
12. SECURE WORK.
Use clamps or a vise to
hold a small workpiece work when practical.
13. DO NOT OVER-REACH.
Keep proper
footing and balance at all times.
14. MAINTAIN TOOLS WITH CARE.
Keep
tools clean and in adjustment for the best
and safest performance. Follow instructions
for changing accessories and lubricating.
15. USE RECOMMENDED ACCESSORIES.
Consult the owner’s manual for recom-
mended accessories. The use of improper
accessories may cause risk of injury.
16. REDUCE THE RISK OF UNINTENTIONAL
STARTING.
On machines with magnetic
contact starting switches there is a risk of
starting if the machine is bumped or jarred.
Always disconnect from power source
before adjusting or servicing. Make sure
switch is in OFF position before reconnect-
ing.
17. CHECK DAMAGED PARTS.
Before further
use of the tool, a guard or other part that
is damaged should be carefully checked
to determine that it will operate properly
and perform its intended function. Check
for alignment of moving parts, binding of
moving parts, breakage of parts, mounting,
and any other conditions that may affect
its operation. A guard or other part that is
damaged should be properly repaired or
replaced.
18. NEVER LEAVE TOOL RUNNING
UNATTENDED. TURN POWER OFF.
DO
NOT leave tool until it comes to a complete
stop.
19. NEVER OPERATE A MACHINE WHEN
TIRED, OR UNDER THE INFLUENCE OF
DRUGS OR ALCOHOL.
Full mental alert-
ness is required at all times when running
a machine.
20. NEVER ALLOW UNSUPERVISED OR
UNTRAINED PERSONNEL TO OPERATE
THE MACHINE.
Make sure any instruc-
tions you give in regards to machine opera-
tion are approved, correct, safe, and clearly
understood.
21.
IF AT ANY TIME YOU ARE EXPERIENC-
ING DIFFICULTIES
performing the intend-
ed operation, stop using the machine! Then
contact our service department or ask a
qualified expert how the operation should
be performed.
LENGTH
AMP RATING 25ft
50ft
100ft
0-6
16
16
16
7-10
16
16
14
11-12
16
16
14
13-16
14
12
12
17-20
12
12
10
21-30
10
10
No
Safety Instructions for Power Tools
Содержание G0530
Страница 18: ...16 G0530 Variable Speed Buffer...