Model G0477
15" Planer/Moulder
-15-
Mounting Planer/
Moulder on Stand
components and hardware Needed:
hex Bolts M8-1.25 x 80 ..................................... 4
Flat Washers 8mm ............................................ 8
hex nuts M8-1.25 ............................................. 4
to mount the planer/moulder to the stand:
1. position the assembled stand so that it is on
a flat, level surface and is clear of nearby
equipment or other obstructions.
2. With the help of an assistant, lift the planer/
moulder onto the stand.
3. Align the mounting holes in the base cast-
ing of the planer/moulder with the mounting
holes in the stand, as shown in
figure 8.
the Model G0477 is a
very heavy machine. Get
assistance when lift-
ing the planer/moulder
onto the stand. failure to
comply can result is seri-
ous personal injury!
4. Fasten the planer/moulder to the stand using
the M8-1.25 x 80 hex bolts, flat washers and
hex nuts.
Dust chute and bag
components and hardware Needed:
Qty
dust Chute ........................................................ 1
Button head Cap screw M6-1 x 25 .................. 1
dust Collection Bag ........................................... 1
Bag Clamp ......................................................... 1
dust Chute Adapter ........................................... 1
Cap screw M6-1 x 25 ........................................ 1
to install the dust chute and bag:
1. Fasten the dust chute on the fan cover using
the button head cap screw.
2. Fit the dust chute adapter over the dust chute
and fasten in place using the cap screw.
3. slip the bag clamp over the neck of the bag,
and fit the bag opening onto the dust chute
adapter.
4. Close the clamp to fasten the bag onto the
dust chute adapter.
5. give the bag a slight tug to ensure it is
secured tightly.
Note: If the clamp seems to be too loose or
too tight when the clamp is engaged, it can
be adjusted by rotating the clamping handle.
Rotate the clamping handle clockwise to
tighten the clamp or counterclockwise to
loosen the clamp.
DO NOt operate the Model G0477 without
the dust collection bag installed. this plan-
er/moulder creates substantial amounts of
wood dust while operating. failure to use the
dust collection bag can result in short and
long-term respiratory illness.
figure 8. Mounting holes in base casting.
Mounting hole
