Grizzly G0453, Руководство пользователя

Страница: 53 / 83

-40-
G0453/G0454 (Mfg. Since 3/08)
Feed Rollers, Chip
Breaker & Pressure
Bar Heights
A & B
C
D
BDC
(Bottom Dead Center)
Figure 42. Planer component recommended
clearances (illustration is not to scale).
Using a Rotacator
Tools Needed Qty
Hex Wrenches 3, 5mm .............................1 Each
Wrench or Socket 10mm ................................... 1
Rotacator (see
Page 28) ................................... 1
1. DISCONNECT PLANER FROM POWER!
2. Make sure the knives are set to the correct
height (refer to
Setting/Replacing Knives
on Page 36 for detailed instructions).
3. Lower the table at least 4" below the head
casting, then lock it in place.
4. Remove the dust hood, top cover, and belt
cover.
5. Using your Rotacator, find the BDC of any
knife edge by slowly rocking the cutterhead
pulley back and forth, then set the Rotacator
dial to zero (see
Figure 43).
Figure 43. Using a Rotacator to find BDC.
It is essential that the feed rollers, chip breaker,
and pressure bar are set at the correct distance
below the cutterhead to ensure that the workpiece
moves through the planer evenly and the correct
distance from the cutterhead knives.
To ensure accurate results and make the adjust-
ment process quicker and easier, we recommend
using a Rotacator for these adjustments (refer to
Page 28).
If a Rotacator is not available, a 6' 2x4 cut into two
even sized pieces and a feeler gauge set can be
used, but care must be taken when jointing the
wood to achieve accurate results.
Dist. Below Knife Edge at BDC (Figure 42)
A. Infeed Roller ....................................... 0.040"
B. Chip Breaker....................................... 0.040"
C. Pressure Bar.......................................0.008"
D. Outfeed Roller .................................... 0.020"
call out components