125
GB
21
15
picture 4
1. Wait until the impeller wheel is still.
2. To remove the collection bag (16),
the retainer loop (see picture 1, nos.
18a+18b) and press the two side click-
in fasteners (21) on the retainer frame
(15) inward.
3. Open the zip fastener (see picture 1,
no. 17) on the collection bag (16) and
empty it completely.
4. Refit the empty collection bag (see
chapter “Assembly Instructions”).
Composting material does not be-
long with domestic waste!
Blowing operating mode:
• Set the operating mode selector
switch to the symbol (see “Initial
Operation”).
• You get optimal results when you use
the blower with a separation distance
to the ground of 5 -10 cm.
• Direct the airstream away from your
-
self. Ensure that you do not to stir up
any heavy objects and hurt somebody
or damage something.
• Begin work with the highest blowing
power, in order to rapidly pile up the
leaves lying around. Select a lower
blowing power to compact the previ-
ously piled up leaves.
• Before blowing, loosen leaves adher
-
ing to the ground with a broom or rake.
• The guide rollers at the end of the tube
make it easier to work on flat surfaces.
Cleaning and mainte-
nance
Pull out the power plug before all
work on the device.
Leave all work not described in
this manual to our Service Cen-
tre. Only use original parts.
Before every use, check the foliage
vacuum for obvious deficiencies,
such as loose, worn or damaged
parts and for correct seating of the
parts. Replace damaged parts.
Check the bag regularly for wear
and tear.
Carry out the following maintenance and
cleaning work regularly. By this means, a
long and reliable life is guaranteed.
General cleaning
Clean the device in each case
immediately after working, since
otherwise mud with leaf residues
hardens and sets
and can pos-
sibly no longer be removed without
dismantling the motor casing.
Such cleaning work is not cov-
ered by the guarantee.
Do not employ any cleaning agents
or solvents. They can irreparably
damage the device. Chemical sub-
stances can attack the plastic parts
of the device.
• Clean the device casing, the tube and
the ventilation slots regularly with a
soft brush or a cloth. Never clean the
device under running water.
• Take off the collection bag after finishing
work, turn it inside out and brush it thor-
Содержание ELS 2614 E
Страница 148: ......