10
4.3 Reading the display and using controls
MENU key: Each time this key is pressed, the display will show the following functions, sequen-
tially:
- address setting;
- manual mode setting.
UP and DOWN keys: by pushing the UP/DOWN keys, the values of the function which is shown
in the display can be changed.
ENTER key: keep the ENTER key pushed for a few seconds (until the display and the green led
light flash), in order to memorize the function which is shown in the display.
Use meter: Push ENTER for more then 5 seconds
4.4 Address setting
Address setting: When you turn the unit on, the display reads the unit address. To change the
address, proceed according to the following instructions: press once the
MENU key to access the address setting. Select the desired value (ranging
from 1 to 512) by using the UP/DOWN keys (see picture on the side). Press
ENTER to confirm.
4.5 Manual Mode
This mode is activated by setting the Man function to the H value, without connecting the DMX
signal. When you turn the unit on, the display reads the unit address. Press
three times the MENU key to select the manual mode. Select the H value
by using the UP/DOWN keys (see picture on the side). Press ENTER to
confirm.
With this setting, the unit performs the PAN MOVEMENT and the MIRROR DISH ROTATION.
Press once the MENU key to change the PAN MOVEMENT speed: the
display reads “S” followed by a figure ranging from 0 to 10, representing
the speed. Set the speed by using the UP/DOWN keys. Press ENTER to
confirm.
Press the MENU key to set the PAN MOVEMENT angle: the display reads
“P” followed by a figure ranging from 1 to 255, representing the angle. Set
the angle by using the UP/DOWN keys. Press ENTER to confirm.
Press the MENU key to set the speed and the direction of the mirror dish rotation: the display reads
“r” followed by a figure ranging from 1 to 255, representing the speed and
the direction of the mirror dish rotation. Set the value by using the
UP/DOWN keys. Press ENTER to confirm.
Press the MENU key to set the black-out function: the display reads “b” followed by a figure ran-
ging from 1 to 255. Set the value by using the UP/DOWN keys. Press
ENTER to confirm. The values from 1 to 32 set the black-out as closed, the
values from 33 to 224 set the strobe effect, while the values from 225 to
255 set the black-out as open.
