17
English
English
17
D.
Warm up the tube by using a heater for heat shrink tubes
“7”
till the complete shrinkage.
The connection so obtained features an
IP67
protection rate.
5.3 Connection to DMX signal
The unit is fitted with a socket XLR3 IP67 for DMX output.
The DMX signal is to be connected by using a shielded
cable designed for devices RS-485.
The signal cable must be connected according to the
following table:
pin 1 = GND
pin 2 = data -
pin 3 = data +
For DMX devices with 5 poles connectors, pins 4 and 5 are
not to be connected.
7
Pin 1: GND
Pin 2: DATA-
Pin 3: DATA+
Terminal
plug IP67
(R=120
ƺ
not included!)
ø 6 MIN
ø 8 MAX
DMX cable size
Warning!
All data wires must be isolated one from another,
from the shield and from the metal housing of the connectors.
Pin number 1 of the housing is not to be connected to the electric ground of the unit.
Insert a terminal plug with a 120 Ω resistor connected to pins 2 and 3 in the last unit.
Use the optional XLR3 connectors code AL1491 and AL1493, in order to preserve the IP67 protection rate.
