7.1 Setting operating mode
By the dip-switch set it is possible to select one of the following operating modes:
• using DMX512 signal control mode
Each fixture is controlled from DMX512 signal control.
• MASTER-SLAVE or AUTOMATIC mode
The projector operates independently, without DMX512 signal control.
7.2 Setting DMX address
To access the dip-switch panel
“12”
it is necessary to untighten the 6 screws
“6”
, open the units, untighten the
screws
“7”
and remove the cover as shown in the following picture.
Two leds are next to the dip-switch panel to notify the status of the unit.
The green led will be on if the unit is powered up.
In the presence of DMX signal, the red led will be steady on, in the absence of signal, the red led will be off, while
in Master mode the red led will flash.
In absence of DMX signal the led will remain OFF.
The number of DMX channels used by the unit to operate will depend from value of dip-switch n°10 and 11
(DMX
MODE)
.
The number of the DMX address is to be calculated by summing the values corresponding to the activated dip-
switches, which are written in the upper side of the dip-switch set (1, 2, 4, 8, 16, etc.).
1 2 3 4 5 6 7 8 9 10 11 12
1
2
4
8
16
32
64
12
8
25
6
M
as
te
r
D
M
X
m
od
e
Example
Unit n°1 with address 001
(dip-switch n°1 = ON)
and
DMX MODE
= 5 channels
Dip 10
Dip 11
Channels number
OFF
OFF
5
ON
OFF
4
OFF
ON
6
ON
ON
5
6
6
7
12
7.0 Use of the unit
26
English
