13
12
TROUBLESHOOTING
MAINTENANCE
MAINTENANCE
Your tool will last longer and perform better if periodic maintenance is
performed. Please use the information below to keep your tool operating in
top condition.
Lubrication
Disconnect tool from the air supply. Apply three drops of air tool oil
(provided) in the air inlet before each use, and after every 1000 fasteners
driven. If the tool will be used outside in the winter, use a winter grade air
tool oil to help keep frost from forming inside the tool. Do not use other
types of lubricants on this tool, as other lubricants may contain chemicals
harmful to o-rings and other tool components.
Cleaning
Disconnect tool from the air supply. Brush tool off using a parts cleaning
brush or clean rag.
Daily Inspection
• Check for broken, damaged, or excessively worn parts, and repair
or replace as needed.
• Check for air leaks at cap, and nose. Disconnect tool from air
supply immediately if leaks are present, and see dealer for service.
• Make sure all screws are tightened securely.
Always disconnect tool from air supply before performing any service on
tool. Correcting a problem while the tool is pressurized may result in
injury from nail drive or tool operation.
DANGER
Your pneumatic fastening tool has been designed for long life and trouble-
free operation. However, if operating problems arise, please use the
troubleshooting information below to determine how to remedy the prob-
lem.
FASTENER DRIVING PROBLEMS
Fasteners do not drive
completely.
Increase air pressure. Do not exceed 120
psi. Add 2 - 3 drops of air tool oil to inlet.
PROBLEM
CORRECTIVE ACTION
Fasteners do not drive
completely after air
pressure is increased.
Driver blade worn or broken. See dealer for
replacement.
Tool leaks air.
Check for source of leak, and tighten fittings
and screws as required. Discontinue using
tool if air leaks after tightening. Contact your
dealer.
TOOL TROUBLESHOOTING
Always disconnect tool from air supply before performing any service on
tool. Correcting a problem while the tool is pressurized may result in
injury from nail drive or tool operation.
DANGER
