Grindmaster CS1-110, Руководство оператора

Страница: 11 / 32

CS Espresso Machine Grindmaster ®® 11
If espresso machine will not be used for an extended
period, will be stored, or transported, drain tank to
prolong life and prevent damage from freezing.
1. Turn off the machine, and release all the pressure
from boiler by turning on the steam knob(s).
2. After the steam is completely released and the
pressure on steam boiler pressure gauge reads “0”,
remove drain tray and locate drain valve under
drain tray. Turn on drain valve to drain water out of
boiler. Drain valve is on when it is parallel to pipe.
NOTE: Please DO NOT turn off the steam knob after the
steam is released for storage. Keep the steam knob on.
When you re-start the machine, do not turn off the
steam knob until you see water drop from the steam
wand. This is to balance the boiler pressure.
3. Turn off drain valve when water stops flowing into
waste cup. Drain valve is off when it is
perpendicular to pipe.
CAUTION: BURN HAZARD
Dispenser surfaces and water inside dispenser are very
hot. Use caution when draining unit to prevent burns.
CAUTION: BURN HAZARD
Never turn on drain valve when there is pressure in
the boiler.
Troubleshooting
Before you call for help, please read the following:
WARNING:
To reduce the risk of electrical shock, unplug the dispenser power cord before repairing or
replacing any internal components of the unit. Before any attempt to replace a component, be sure to check all
electrical connections for proper contact. Only a qualified service technician should perform electrical and
mechanical adjustments or repairs.
Note: Wait at least 3 seconds to restart the machine after turning it off to ensure previous error stored in memory
is cleared.
If you need help, call Grindmaster-Cecilware Technical Service Department, (502) 425-4776 or (800) 695-4500 (USA
& Canada only) (Monday through Friday 8 AM - 6 PM EST). Please have the model and serial number ready so
that accurate information can be given.
Prior authorization must be obtained from Grindmaster-Cecilware for all warranty claims.
Grindmaster-Cecilware provides the industry’s BEST warranty. Visit our website at gmcw.com for
warranty terms and conditions.
INDICATION PROBABLE CAUSE SOLUTION
All lights on control •
After two minutes of
•
Water level probe not
•
Make sure that the water
panel turn on water input, indicator
functioning properly.
valve is turned on and
still does not show a there is water flowing
rise in machine water into machine.
level. It will take more •
Water intake solenoid is
• Turn off machine. Restart
than two minutes to
out of order.
after 3 seconds.
replenish water when •
Input water flow has been
• Turn water supply on.
the machine is used
interrupted.
for the first time.
All lights on ONE • No water output • Coffee grounds are too • Adjust fineness of coffee
control panel flash from brewing group. fine. grinds.
• Brewing for a long • Water intake solenoid is • Turn off machine. Restart
time without reaching out of order. after 3 seconds.
setup value. • Flow meter is out of order. • Press any key to eliminate
the breakdown signal,
and notify qualified service
technician.
Draining