Grill'D Dubravo, Инструкция по установке и эксплуатации

Страница: 41 / 78

41
Table 2. Safety distances
A min. B min. C min. D min. E F
1000 500 500 800 50 100
Note: dimensions are in millimeters.
3.2. Heater installation
IMPORTANT! Ensure proper floor levelling for the heater installation; possible slants of the
heater and the chimney are precluded.
3.2.1. Stone chimney connection
The diameter of hole for connection to the chimney stack shall be about 20 mm larger than
the diameter of the heating flue outlet pipe, so the optimum clearance around the pipe is
about 10 mm.
If the designed pipe inlet to the stone chimney is at 90°, it is recommended to make the
inner edges of the chimney stack bore round (Figure 5) in order to reduce the resistance for
flue gas passage.
If you plan to use a heater rack, for example, then take into account the height of the heater
together with the rack when preparing the hole.
Procedure:
1. Install the heater on the place of permanent operation.
2. Install a water tank, if any. Keep in mind the requirements of its operations manual.
3. A valve can be installed on the connecting pipe, if additional adjustment of draft is
necessary. Install, if any.
4. Insert the connecting pipe into the stone chimney. Do not push the connecting pipe too
deep into the stone chimney, as you can block it.
5. Connect the heater with the pipe inserted into the stone chimney.
6. Ensure that all the pipe connections and the heater connection are reliable..
7. Seal the gap between the pipe and the wall using non-combustible mineral wool, for
example.
8. Make sure that the air-tight seal is good. Add mineral wool, if necessary.
Figure 4 .
Safety distances