Griffon SWINGLOX, Инструкция по эксплуатации

Страница: 11 / 17

SWINGLOX
Note:
•
Can only be executed with the master code.
•
This function can only be turned off during the opening window (after the opening
delay time has passed).
After this function has been turned off, the opening window will run for one last time. Code
entry for opening is possible.
Enter code 6 5 4 3 2 1 (example)

onstantly




Aperture delay time is
running
 
ev. 2 sec.
Start Opening window

and altern

ately in 1 second cycle
Special function 9 starts 9
 
constantly
   
Master code 1 2 3 4 5 6 (example)

constantly
   
Opening delay
• exhibit: 00
0 0
function
off

constantly
Opening window
Value between 01 und 19
0 1 (example)

constantly


Repeat entry
0 0
0 1 (example)
(example)

off




Opening with Opening Delay activated
Note:
• Entering an invalid code during the opening delay time will cancel the entire process
• Entry of two valid codes within the opening window with Flash 4 only (see Opening after
Dual Mode Operation ).
Enter code 6 5 4 3 2 1 (example)

constantly
   
Opening delay time is
running
 
ev. 2 sec.
Opening window starts

and altern

ately in 1 second cycle
Re-enter valid code
(within the opening
window)
6 5 4 3 2 1 (example)




After the signal for
correct input, turn the
handle of the safe
within 3 sec.
Opening Delay Override (Quick Open Code) (Flash 5)
Note:
• User no. 9 must be active (see special function 1).
• Users must be turned on (see special function 2).
• The first code (code for starting the opening delay) may not be user no. 9’s code.
Enter the code 6 5 4 3 2 1 (example)

constantly




Time delay time is
running
 
ev. 2 sec.
Enter user no. 9’s code 3 2 1 6 5 4 (example)
   
After the signal for
correct input, turn the
handle of the safe within
3 sec.
Security Information:
• Any records of the used code shall be stowed in a way that they are not accessible to third
parties.
• When entering the code, make sure that the input cannot be observed by bystanders.
Removing the keypad
The cable duct for the lock and the battery are located behind the keypad housing.
To remove the keypad housing, turn the housing to the left to the mark on the top of the case.
ATTENTION: during assembly/disassembly of the keyboard housing make sure there is an
exact match between the marking of the housing and the indicator marks 1or2.
Lift off the keypad housing, paying attention to the connection cable.