Grifco DDEB-1R, Руководство пользователя

Страница: 7 / 10

D-M-ACG-122 D-Drive Relay Expansion
Module Manual
7 2-Aug-22
7. Relay Output Configuration
To configure an output of the controller to the onboard and plug-in Relay Modules, navigate to the
appropriate P.70x setting (where ‘x’ is the number of the Output to be configured) and change the saved
setting to an option in the table below:
Setting Description
0000 Output deactivated
0001 Continuously turned on
0101 Door is Open
The message depends on the logical status of the door
0103 Door is Open
The message depends on the logical status of the door
0201 Door is Closed
The message depends on the logical status of the door
0203 Door is Closed
The message depends on the logical status of the door
0401 There is no error
0501 Courtyard light function, switched ON during opening and closing with 10 s switch off delay after
closing.
0601 Passing on detector channel 1
0602 Passing on detector channel 2
0605 Synchronous control OPEN, signal duration 0.5 seconds.
The output is active during opening, in End position OPEN and during locking in end open
position.
0606 Synchronous control CLOSE, signal duration 0.5 seconds.
The output is active during Closing, in End position Close and during locking in end position close.
0607 Synchronous control STOP, signal duration 0.5 seconds.
The output is active when the door is not moving, no end position is approached and no locking in
any end position is active.
0612 Passing on leaving detector 1
0613 Passing on leaving detector 2
0630 Forwarding Brake
0634 Forwarding, of an low Battery from the WiCab mobile Unit
0659 F.363: forwarding disturbance of the internal safety edge.
0660 Forwarding: maximum number of trips of the safety edges has been exceeded.
0665 Forwarding detector channel 3
0666 Forwarding detector channel 4
0701 Flashing during opening and closing
0703 Switched on during Opening and Closing
0801 Active during opening and closing and during active pre-warning / clearance time.
1001 Locking second door
1002 Locking second door, 1 s switch off delay
1101 Magnet voltage in end position CLOSE
The N.C. contact of the relay has to be used
1102 Magnet voltage during Closing and in end position CLOSE