Griesser 179086, Руководство по эксплуатации

Страница: 18 / 24

32 | EN
EN | 33
Expert submenu
"All On/Off"
The master channel is available in the factory setting:
"All On".
If this is not wanted or does not appear appropriate
(e.g. with mixed operation with roller shutters and awnings),
the function can be disabled with "All Off".
If the "All Off" setting is selected, the control and
programming options of the master channel are disabled.
"INFO On/Off"
On or Off function for the periodic query of the individual
channels when starting and during travel motion in the
group or in the master channel. The shut-off of radio traf
fi c
during transmission in the group can be greatly reduced
depending on the individual channels in the group or in
the master channel. In the case of cut-out the position
display is updated by the internal of the transmitter.
"Version" submenu
Display of current fi rmware version
4.6 Programming the transmitter
A maximum of 15 individual channels is available for
programming receivers. Press the selection key brie
fl y
to allow all channels to be available for selection for
programming for 30 seconds. After selection of the channel
the programming process can be started with the
P key.
All channels will also be displayed during the programming
process if a programming process is started with the
P key.
During a programming process the user can switch between
empty and previously programmed channels (except when
programming a channel with more than 10 simultaneous
receivers).
Condition :
The bidirectional receiver is installed.
For programming in front of the programmed blind.
1. With electrical receivers which have already been
installed, switch the fuse off, and on again a few seconds
later. The receiver is now in programming mode for about
5 minutes.
2. Press the programming key P on the back of the device
brie fl y (approx. 1 second) until the status display lights
up brie fl y. The blind moves up and down for approx. two
minutes, showing that the receiver is in programming
mode.
3. Press the OPEN key immediately (maximum 1 second)
after the start of a upward movement. The status display
lights up brie
fl y.
The blind stops brie fl y, starts moving again and then
moves downwards.
4. Press the OPEN key immediately (maximum 1 second)
after the start of a upward movement. The status display
lights up brie
fl y. The blind stops. The channel is now
programmed by the transmitter.