Greystone DK213-21AS, Инструкция по эксплуатации

Страница: 17 / 28

17
- if there is a gas leak detected
，
replace the defective part
recommended by the manufacturer or tighten the loose joint
properly
-Leak testing of the appliance shall be conducted according to the
manufacturer’s instructions.
Do not use a flame to check for gas leaks.
Use a brush to spread a soapy water mixture around the area you are
checking. If there is a gas leak, you will see small bubbles in the soapy
water mixture at the leak point.
A manual valve shall be installed in an accessible location in the gas
piping external to the appliance for the purpose of turning on or shutting
off gas to the appliance.
NEVER cover any slots,holes or passages in the oven bottom or cover an
entire rack with materials such as aluminum foil.Doing so blocks aireflow
through the oven and may cause carbon monoxide poisoning. Aluminum
foil linings may also trap heat, causing a fire hazard.
Top burner flame size should be adjusted so it does not extend beyond
the edge of the cooking utensil. This instruction is based on safety
considerations. Possible hazards or injuries may result from the misuse of
appliance doors or drawers, such as stepping, leaning, or sitting on the
doors or drawers.
BEFORE TESTING FOR GAS LEAK
1.Ensure gas range controls are in their OFF positions.
2.Never test for leaks with any open flames present.
3.Do not smoke when testing for gas leaks.
4.Use a soapy solution to detect gas leaks,If there are bubbles
present,there is a gas leak.