Greyline Instruments SFM 6.1, Инструкция по установке и эксплуатации

Страница: 20 / 41

Page 20
SFM 6.1 Slurry Flow Meter
ENCLOSURE INSTALLATION
Locate the enclosure within 20 ft (6 m) of the sensor (500 ft -150 m optional). The enclosure can be wall
mounted with the four mounting screws (included).
Avoid mounting the enclosure in direct sunlight to protect the electronics from damage due to
overheating and condensate. In high humidity atmospheres, or where temperatures fall below freezing,
Option TH Enclosure Heater and Thermostat is recommended. Seal conduit entries to prevent moisture
from entering enclosure.
NEMA4X STAINLESS STEEL
Insert #14 screws (supplied) through the four enclosure mounting
holes to secure the enclosure to the wall or mounting stand.
Additional conduit holes can be cut in the bottom of the enclosure
when required. Use a carbide tipped hole cutter to cut the required
holes.
DO NOT make conduit/wiring entries into the top of the enclosure.
Note: Grounding must be provided as part of the installation. Ground
in accordance with the requirements of the National Electrical Code.
System grounding is provided by connecting grounding wires from
all conduit entries to the steel mounting plate or another point which
provides continuity.
CLEANING
Cleaning is not required as a part of normal maintenance.