H60.0.11.6C-16
Operating Manual GMH 3830
Page 6 of 18
_____________________________________________________
_____________________________________________________________________________
4 Device Configuration
For configuration of the device press "
Menu
"-key (key 4) for 2 seconds, the first menu will be shown.
Choose between the individual values that can be set by pressing the "
Menu
"-key (key 4) again.
The individual values are changed by pressing the keys "
" (key 2) or "
" (key 5).
Use key "
Store/
" (key 6) to leave configuration and to store settings.
Parameter
Values
Meaning
key
Menu
key
or
p.r.t.
Sort: limitation of the material selection
off
:
Unrestricted material selection via key 2 and 5
1...8
:
Material selection in-between 1 up to 8 selectable materials
....
selectable materials (not available if Sort = off)
Select the desired material that should be available during
the measure via key 2 and 5.
Generic Settings
Arrow bottom left
points to
“%u”
Moisture display = moisture content [%u]
Arrow bottom left
points to
“%w”
Moisture display = wet-basis moisture content [%u]
°C
All temperature values are in degrees Celsius
°F
All temperature values are in degrees Fahrenheit
oFF
Atc off: temperature input for compensation via keys
5.4
on
Atc on: temperature compensation via internally measured temperature
or external probe
oFF
Auto HLD off: continuous measuring.
5.3
on
Auto-HLD on: when reaching a stable measuring result, this will be
frozen with-HLD. When pressing the store-key a new measure will be
initiated. If logger is switched on (‚Func CYCL‘, ‚Func Stor‘): device
works like setting would be “auto-HLD off”
1...120
Power-off delay in minutes.
Device will be automatically switched off as soon as this time has
elapsed if no key is pressed/no interface communication takes place
oFF
Power-off function inactive (continuous operation, e.g. mains operation)
oFF
Function of the output: No output function, lowest power consumption
SEr
Output is serial interface
dAC
Output is analogue output 0...1V
01, 11 ... 91
Base Address when Output = Serial Interface :
Base address of device for interface communication.
7.1
0.0 ... 100.0%
Enter desired moisture value at which the analogue output potential
should be 0V
7.2
0.0 ... 100.0%
Enter desired moisture value at which the analogue output potential
should be 1V
7.2
The settings will be set to the settings ex works, if keys ‘Set‘ and ‘Store‘ are pressed
simultaneously for more than 2 seconds.
