E35.0.01.6C-03 Manual for connection and operation of the EB 3000 page 8 of 19
5. Commissioning and configuration of the EB3000
For configuration and commissioning of the EB3000 the software
EASYBus-configurator
is necessary. You
will find this software for free on one of our different product-CD’s or on homepage
under
area SERVICE beneath FREEWARE.
5.1. Initial commissioning of the EB3000
Before commissioning the EB3000, a proper and complete installation and wiring of the entire EASYBus-
system is required.
Please start software
EASYBus-Configurator
and carry out a system initialisation. For further details read
the operating manual of the
EASYBus-Configurator.
By double-click on EB3000-symbol the EB3000-configuration window appears.
Choose register-tab monitoring / display and make following settings for each channel:
-
allocation of a measurement channel
-
setting of the required timeout
-
setting of display endurance, text for auxiliary display and appearance of the unit-LED’s
Choose register-tab control outputs and make following settings for each output:
-
allocation of a channel number
-
setting of switching-on-point, switching-off-point, switching-delay and function
To use EB3000 calculation functions, choose register-tab virtual channels for programming the desired func-
tion for virtual channel 1 or 2.
For details see chapter 9. EB3000-Configuration
6. Operation of the EB3000
Hint:
Keys 2 and 3 are equipped with a 'roll-function' for an easy input of values. By pushing this key shortly the
display increases (key 2) resp. decreases (key 3) at any one time about 1 digit.
By pushing the keys longer than 1 second the value starts to count up resp. to count down, whereas the
counting speed increases after a short time.
6.1. How to display the current measurement values
In the standard mode the current measurement values (actual values) of the measurement channels will be
displayed in the main display.
In the auxiliary display the text appears, which was configured for the respective channel.
There are two modes of display:
Static display:
The selected channel will be displayed constantly; use keys 2 (up) and 3 (down) for channel selection.
Cyclic display:
All channels will be indicated one after another by the adjusted display endurance. By configuration display
endurance can be set for each channel separately (see chapter 5). If cyclic display is activated, the decimal
point right next to the auxiliary display illuminates.
Key-operating:
- key
2
and
3
shortly pushed:
cyclic display switches on/off
- key
2
shortly pushed:
displaying of next channel
- key
3
shortly pushed:
displaying of previous channel
