1. Open the battery door.
2. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
3. Push the battery pack into the battery compartment
until the battery pack locks into place.
4. When you hear a click, the battery pack is installed.
5. Close the battery door.
TIP
The machine has a battery storage compartment that
helps store the battery pack.
8.7
REMOVE THE BATTERY PACK
Figure 5
1. Open the battery door.
2. Push and hold the battery release button.
3. Remove the battery pack from the machine.
9
OPERATION
WARNING
Do not handle battery pack, switch, or machine with
wet hands. Do not expose to rain or allow liquid to
enter the motor compartment.
9.1
START THE MACHINE
Figure 6
1. Push the on/off button to turn the machine on.
WARNING
Hold the machine with hands during operation.
NOTE
If you want to start the machine again please wait until
the machine completely stops.
9.2
STOP THE MACHINE
Figure 6
1. Set the on/off button to off position.
9.3
BLOWING FEATURE
Figure 7
It can blow sawdust and other debris. Follow the steps
below to use your vac as a blower.
1. Install the locking end of hose into the blowing port.
2. Attach the desired accessory to the end of hose.
3. Start the machine.
9.4
OPERATION TIPS
• The filter must always be in correct position to avoid
leaks and possible damage to the machine.
• When you use your machine, it will be necessary for
you to empty the collection tank and clean the filter
at more frequent intervals to maintain peak vac
performance.
• When the liquid in the collection tank reaches a
predetermined level, the float mechanism will rise
automatically to cut off air-flow. This will cause the
suction stop and the higher motor noise. When this
happens:
1. Turn off the machine.
2. Remove the battery pack.
3. Empty the collection tank.
• Dry the filter after you use the machine to avoid
mildew and damage to the machine.
10
MAINTENANCE
CAUTION
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
WARNING
Remove the battery pack from the machine before
maintenance.
10.1 CLEAN THE FILTER
NOTE
Allow the filter to dry before you store or picking up
debris.
Often clean your filter to maintain peak vac
performance.
Clean a dry filter:
• Cleaning should be done outdoors and not in the
living quarters.
• You can use a small brush to clean the dust and
debris.
• For thorough cleaning of dry filter with fine dust (no
debris), run water through it as described under
"Cleaning A Wet Filter"
Clean a wet filter:
1. Remove the filter from the machine.
8
English
EN
