GreenWorks ID24B00, Руководство пользователя, Страница: 11 / 56

11
OPERATION
To stop the driver, release the switch trigger and allow the coupler to come to a complete stop.
C A U T I O N
To prevent gear damage, always allow the coupler to come to a complete stop before changing the
direction of rotation.
INSTALLING/REMOVING BITS
Fig.5
Coupler
Bit
The coupler has been designed to accept 1/4 in. hex bits.
To install:
■ Lock switch trigger on the tool by placing the direction of rotation selector in center position.
■ Slide the coupler forward and hold in position.
■ Insert bit straight into coupler.
■ Slide the coupler back slowly and release.
NOTE: Use only impact quality bits with a locking groove.
W A R N I N G
Make sure the bit is secured in the coupler before using the impact driver. Failure to do so could cause
seriouspersonal injury.
To remove:
■ Lock the switch trigger by placing the direction of rotation selector in the center position.
■ Slide the coupler forward and hold in position.
■ Pull the bit straight out of the coupler.
W A R N I N G
Do not drive a screw where there is likely to be hidden wiring behind the surface. Contact with a “live”
wire will make exposed metal parts of the tool “live” and shock the operator. If you must drive a screw
where hidden wire could be present, always hold tool by insulated gripping surfaces (handle) when
performing the operation to prevent a shock to the operator.
C A U T I O N
The impact driver is not designed to be used as a drill.