28
MAINTENANCE
QUICK REFERENCE OF CHAIN & BAR ASSEMBLY
NOTE:
•
Chains stretch with use, check and tension often.
•
Never tension a warm chain before storing, as chains shrink when cool, this can damage
chain bar and saw.
1. To remove the side cover, loosen
the locking knob one full turn
counterclockwise.
2. Then loosen the chain tension knob 2
or 3 turns.
3. Now totally remove the locking knob
and remove the side cover.
4. The bar and chain can now be removed
by lifting it away from the main body of
the saw and releasing the chain from
the drive pulley.
5. The chainsaw can now be cleaned with
a brush and or rag to remove sawdust
and oil.
6. To replace the bar and chain, loop the
chain over the drive pulley and place
the bar against the centre alignment
groove.
7. Ensure that the adjusting block is
located in the tensioning hole on
the chain bar.
8. And that the rubber block and chain
bar are free from oil, as this helps to
keep tension on the chain.
9. Replace the side cover and locking
knob, but do not tighten.
10. Turn the tension knob Clockwise
to tighten the chain.
11. Until there is enough play that the
chain can be pulled away from the bar,
but not so much that the runners can
be pulled out of the bar.
12. Once you have the correct tension,
fully tighten the locking knob.
ADJUSTING
BLOCK
Содержание 2000800
Страница 38: ...38 EXPLODED VIEW...