GreenWorks Tools 2100207, Руководство пользователя

Страница: 5 / 17

English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SV HR HU RO BG EL AR TR HE LT LV ET
ADJUSTABLE CUTTING DIAMETER
The trimmer is currently set at a 14 in. cutting swath. To
adjust to a cutting swath of 16 in.:
„
Remove the battery from the string trimmer.
„
Remove both screws on the cut-off blade with a Phillips
screwdriver (not included).
„
Rotate the cut-off blade 180°.
„
Replace both screws in the cut-off blade.
Note:
Set the cut-off blade to 14 in. for greater runtime. Set
the cut-off blade to 16 in. for greater cutting area.
Note: a smaller diameter cutting path will maximize run
time and cutting speed, while a larger cutting path will help
complete the trimming task quicker.
LINE CUT-OFF BLADE
This trimmer is equipped with a line cut-off blade on the
grass deflector. For best cutting, advance line until it
is trimmed to length by the line cut-off blade. Advance
line whenever you hear the engine running faster than
normal, or when trimming efficiency diminishes. This will
maintain best performance and keep line long enough to
advance properly.
WARNING
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
GENERAL MAINTENANCE
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced.
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
Only the parts shown on the parts list are intended to
be repaired or replaced by the customer. All other parts
should be replaced at an Authorised Service Centre.
WARNING
To avoid serious personal injury, always remove the
battery pack from the tool when cleaning or performing
any maintenance.
SPOOL REPLACEMENT See Figure 7.
Use original manufacturer’s replacement cutting line for
best performance.
„
Remove the battery pack.
„
Push in tabs on side of spool cover.
„
Pull spool cover up to remove.
„
Remove the old spool.
„
To install the new spool, make sure the cutting line is
captured in the slot on the new spool. Make sure the
end of the cutting line is extended approximately 15cm
beyond the slot.
„
Install the new spool so that the cutting line and slot
align with the eyelet in the cutting head. Thread the
cutting line into the eyelet.
„
Pull the cutting line extending from the cutting head so
the cutting line releases from the slot in the spool.
„
Reinstall the spool cover by depressing tabs into slots
and pushing down until spool cover clicks into place.
4