Operating Instructions
The firebox main power “on/off” switch (see Fig. 4) must be switched “on” before any of the control
functions, (on the firebox and/or remote control) will operate.
NOTE:
The main switch does not have to
be turned off when the firebox is not being used for brief time periods. If however, you are not planning
to use your firebox for extended time periods or going away on vacation, we recommend the main power
“on/off” be switched off.
This firebox insert features conveniently separate controls for the flame effect and heat control.
This feature allows you to operate the unit in 2 different ways;
• As a full featured fireplace insert with both flame effect and heater operating simultaneously.
• As a visual effect with flame effect only. (i.e. no heating cycle)
NOTE:
This firebox insert is not designed to operate in “heat” only mode without a flame effect.
All of the firebox control functions can be accessed in 2 ways:
4
Using the remote control (fig.3):
1. Main Power Button:
Press the “main power button”
on the firebox, the flame effect (only) will turn on.
To turn the firebox “off” press the “main power
button” again. The firebox will "fade out" in
approximately 30 seconds.
2. Flame Effect:
Press the flame up or down button
through the 5 settings to achieve the desired effect
(no heat).
3. Heat:
Press the up button once for “ultra-high” heat
setting; down once for “high” heat setting; down
twice for “medium” heat setting a third time for
“low” setting (
NOTE:
the flame effect is always on
when the heat cycle is operational) Pressing the
down button a “fourth” time turns the heater off.
4. Down Light Button:
This button illuminates the top
light.
Using the manual controls located on the firebox behind
the upper front access panel (fig. 4):
1. Main Power Button:
Press the “main power
button” on the firebox, the flame effect (only)
will turn on. To turn the firebox “off” press the
“main power button” again. The firebox will
"fade out" in approximately 30 seconds.
2. Flame Effect:
Press the flame button to achieve
the desired effect (no heat).
3. Heat:
Press the button once for “ultra-high” heat
setting; twice for “high” heat setting; three times
for “medium” heat setting a fourth time for “low”
setting (
NOTE:
the flame effect is always on
when the heat cycle is operational) Pressing the
button a “fifth” time turns the heater off.
4. Down Light Button:
This button illuminates the top
light.
Fig. 3
Fig. 4
1
4
3
2
4
3
2
1
