GreenTech Pure Water ALKALINE Ti, Руководство пользователя

Страница: 11 / 16

11
CUSTOMIZING SETTINGS
Electrolysis Intensity
The water first travels from your tap through a USA Made NSF-Certified Carbon filter where
The Electrolysis Intensity Setting is designed to help you calibrate each level of pH on
your Alkaline XT Water Ionizer. Water quality can affect the output level of pH from your
machine. Use the pH test kit provided to ensure accurate pH output for each level. Use
the Electrolysis Intensity Setting to adjust if necessary.
Note: The flow rate of water running through your machine can affect the pH level.
Slower Flow = Higher pH Level. When testing, use the same flow rate of water for each level.
Note: The conductivity of the water (measured in TDS) can affect the pH level.
Before setting Electrolysis Intensity, turn off tap (unit power should still be on).
Select the level you wish to adjust (i.e. “Alkaline 4, Alkaline 3, etc.) and hold the button for
5 seconds until the LED Display lights up.
Press the “RESET” button to adjust the electrolysis intensity.
Strong Setting: The Red and Yellow lights will flash.
Medium Setting: The Red light will flash.
Weak Setting: The yellow setting will flash.
Once the desired electrolysis intensity level is reached, press the same level button (i.e.
“Alkaline 4, Alkaline 3, etc.) once more to set the electrolysis intensity.
Using your pH Test Kit
Remove the test liquid from the container and place 2 small drops inside. Select your
desired setting of water and partially fill using a steady stream. Refer to your supplied pH
card to check the accuracy of your setting.
Note: For better accuracy, allow 5-7 seconds of running water for your Ionizer to change its pH to the
desired setting before testing the water.