GreenTec HX 170, Руководство пользователя

Страница: 15 / 27

Cutterbar HX 170-230-270
15
Prior to start-up of work
Setting of Working Posture

Remove any transport protection and swing the arm into working posture.

Start the tool with a low oil flow (low RPMs / low oil flow).

Adjust the HX 170 - 230 – 270 to vertical hedge cutting and raise it to the
working posture.
Starting the Tool

Select low engine RPMs

Ensure that the area around the tool is secured.

Warm start – Start the tool.

Cold start – Never start with max. oil flow. Allow the tool to run without too
much load for about 15 min. to heat up the oil.

Slowly increase the amount of oil until the relevant speed has been achieved.

Never attempt to restart a loaded tool. Remove whatever is stuck before
restarting the tool.
Stopping the Tool

Reduce the engine RPM to fast idling. Stop the tool.

Never quickly increase or reduce the amount of oil as this may damage the
hydraulic system in the long term.

Place the tool on the ground when taking a break.
Driving Instructions
We recommend that you drive slowly at first and pay attention to the terrain and
whether the hedge is free from fencing wire, steel poles and other foreign objects.
Adjust the cutting angle to a position approx. 90 degrees relative to the branches. In
case of large branches, adjust the cutting height to the center of the cutting opening.
Never drive too fast to allow clean cutting.
Low speeds = Nice cuts, nothing sticks out.
High speeds = Frayed cuts, twigs sticking out.