Greenheck FGI, Руководство по сборке

Страница: 9 / 12

Fabra Hood • Form B 9
®
Step 10 – Install HOOD PANELS to HOOD RAIL ASSEMBLY
Place the next hood panel by interlocking each panel as shown in Figure 7, Detail E. Secure each hood panel to
the hood rail assembly as it is put in place, using four #12-14 x 1 inch self-tapping screws (hardware kit # 415450)
to attach the hood panel to the hat channel. Use four #12-11 x 5/8 sheet metal screws (hardware kit # 417467) to
attach the hood panel to the hood rail assembly. Using quantity 10 sheet metal screws (hardware kit # 416900) with
sealing washers per hood panel. Place the remaining hood panels in place with the hood end assembly with the
female rib is to be installed last as shown in step 9.
IMPORTANT: Do not drive sheet metal screws all the way through both sides of the ribs as this could allow water to
leak through the hood. Screws are to fasten only the first 2 layers of the rib joint.
1/4 -20 x 1 in.
THREAD ROLLING SCREW WITH WASHER
NO. 12 -14 x 1 in.
SELF TAPPING SCREW (QTY OF 10 PER RIB)
USE PROVIDED HARDWARE KIT
# 415450 AND 417119
Step 11 – Lift HOOD ASSEMBLY onto HOOD BASE
Lift completed hood assembly onto the hood base and attach the hood assembly to the hood support angles, using
3/8 x 3/4 inch bolt with 3/8 inch Nyloc nut at each attachment point.
Step 12 – Tighten fasteners
Tighten all pivot bracket fasteners.
NOTE: There may be extra fasteners.
Figure 9