Greenheck FGI, Руководство по сборке

Страница: 2 / 12

Fabra Hood • Form B 2
®
Step 3 – Attach HOOD BASE ENDS to HOOD BASE SIDES
Attach the hood support angle to the base assembly, using four 1/4-20 fasteners per angle, see Figure 3, Detail B.
On some units, two diagonal braces come pre-attached to the hood support angle. Fasten the loose end of the
diagonal braces to the base assembly, using one 1/4-20 fastener per diagonal brace. See Figure 3, Detail C.
BASE
ASSEMBLY
HOOD SUPPORT
ANGLE
DETAIL B
BASE
ASSEMBLY
HOOD SUPPORT
ANGLE
DETAIL C
DIAGONAL
BRACE
Step 4 – Tighten fasteners and caulk all inside corners
Tighten all fasteners. Caulk all inside corners where the base sections come together. At this point, the base may be
lifted onto the roof curb before proceeding with further assembly.
Step 5 – Attach SIDE BIRDSCREEN ASSEMBLY to HOOD SUPPORT ANGLE
Attach the side bird screen assembly to the hood support angle and base assembly using four 1/4-20 x 1 inch
fasteners per screen assembly, see Figure 4.
SIDE BIRDSCREEN
ASSEMBLY
SIDE BIRDSCREEN
ASSEMBLY
BASE ASSEMBLY
HOOD SUPPORT
ANGLE
Figure 4
Figure 3