4
System Reset and Clear Commands
LiteKeeper® 4
System Reset and Clear Commands
Under certain circumstances, you may want to reset the
LiteKeeper 4®. There are two different types of reset
commands available in the LiteKeeper 4® system: a soft
reset command and a clear reset command.
Soft Reset Command:
The Soft Reset Command reboots the
microprocessor. It will not cause loss of panel programming.
To perform a Soft Reset Command, press and then
immediately release the reset button located above the
switch wiring channels in the low voltage section. The
display will go blank then read “Initializing…”
Clear Settings Command:
A clear settings command is
used to remove all programming from a LiteKeeper 4®
unit. It should be done before programming to the unit
for the first time or when asked to by a Technical Support
representative. Please use caution with this command!
When performing a Clear command, all relay loads will turn
OFF. Use the ALL ON override switch to keep lighting ON if
necessary.
To Perform a Clear Command:
Reset the panel, using
the Reset Button. Wait for the screen to initialize. Hit
the key sequence “A, B, C, D, *.” The display will read
“Initializing” again. The unit is now cleared to factory default
programming.
Programming the LiteKeeper 4
The LiteKeeper 4® is programmed either through the
keypad onboard interface or through the optional Keeper
Enterprise Software. Please refer to Programming Guide
that came with the unit to program via the keypad or to your
Keeper Enterprise Manual for programming details. It is
recommended that a Clear Settings command be performed
on the controller before the first programming is done to
clear any test data that may be left in the controller from
factory testing.
Repair Information
If a repair becomes necessary on your LiteKeeper 4® unit,
please refer all service to Greengate technical support line
at 1-800-553-3879.
0
*
#
D
5
8
2
4
7
1
6
B
9
C
3
A
ON
+24
OFF
+24
ON
+24
OFF
+24
ON
OFF
ON
OFF
DC GND
+24VDC
Item Reference Drawing
Keyboard
Display
Reset
Switch
Status LEDs
Neutral (White)
Transformer
Output
Relays
High Voltage Wiring Compartment
Low Voltage Wiring
Compartment
Barrier Created When High
Voltage Door Is Closed.
120V (Blac
k) or 277V (Orange) P
ower
Physical
Override
Low Voltage
Switch Inputs
LIGHTING CONTROL
12:00 01/01/08
