Issue 9 February 2006
16
2.4 Using the Sweep mode
2.4.1 Switching to Sweep mode
With the engine running, use the top left switch on the switch column to switch to
Sweep mode (switch in middle position)
2.4.2 Water system
While sweeping, set the water pump on/off with this switch
Front water jets:
When the water pump is on, you can set the
amount of water provided to the brushes by turning this control valve
(to your left)
The jet can be cleaned by removing the jet holder (half turn).
Fan casing drenching jet (located at the inlet duct of the fan casing) is
operational whenever the water pump is on. The jet can be removed
for cleaning by pulling the jet assembly out of its socket.
Wet weather sweeping:
When sweeping in the rain or sweeping in
an area where there are many puddles, the water pump should be switched off.
Dry weather sweeping:
When using the brushes in a dry area, make sure you use the front water jets.
If the water system does not work, check the water tank level at the
back of the vehicle behind the hopper skirt (refer to fault finding
section if the water system still does not work).
The water mesh filter, located under the rear water tank, must be
cleaned regularly.
STOP
Always switch on the water pump when sweeping in a dry area
STOP
Always drain all water from the tank when conditions are frosty
