The Electrical System is Now Ready!
• Fold the kickstand from the ground, then sit on the seat. Put one foot on the pedal and the other
on the ground.
• Now, start pedaling and the engine will go into action. There will be a faint rustle of the pass-
through.
• To maintain battery life, do not use it until its end. When the battery meter flashes, turn off the
power switch and use the pedal as a regular bicycle. After recharging, you can ride again with the
electric motor.
• Back Injury: The rear of the bike is not intended to carry people. Maximum load is up to 25 kg,
and the luggage should be tied with straps and tested during riding.
• Park in a safe place that is not an obstacle to vehicles or pedestrians. Place the bike on the
kickstand, disconnect the power with the main switch and pull the key out of the lock.
• The bike must be locked with a massive lock and difficult to steal. It is recommended to
take the
battery with you.
• Charging: The battery must be charged only with the charger supplied with the bike.
Charging with a different charger can damage the battery and will void the warranty.
Do not open the battery or charger for testing or repair!
Bring to Green Bike Electric Motion
authorized repair shop for testing!
• Charging takes up to 6 hours, depending on battery status. The battery can be charged both on
and off the bike.
• The charging cable must first be connected to the battery and then to the mains socket.
• When the charge indicator light is red, the battery is charging. When the charge light turns green,
the battery is full and must be disconnected from the power source. When charging, the battery
must be properly positioned and not fall or be damaged.
•
The charger becomes hot during charging. Keep it away from any flammable materials
and keep the vents unblocked
• Be sure to properly dispose of dead batteries at proper recycling plants and do not throw away in
the trash.
• Before beginning the ride, check that all the indicator lights are working and the battery is locked
in place.
• Check that the electrical contacts of the battery are always clean. Clean with a dry cloth without
moisture.
• Check tire pressure regularly (40 PSI). Poor pressure will cause overuse of the battery and
shorten cycling time.
• Do not drive in puddles. If water enters the engine, the controller or the battery house may
become damaged. Water damage will void the warranty provided by the manufacturer.
*Store the bike in a dry place. Moisture causes corrosion!
Do not leave the bike in the rain.
Immediately treat the corrosion with suitable oil! Water penetration into the electrical mechanisms
