20
φ55mm
φ55mm
Ø
55
Fig.6
Install the rear panel
1. Always mount the rear panel horizontally. As the water drainage pipe at the left, when
adjusting the rear panel, this side should not be too high; the right side should be slightly high.
2.
Fix the rear panel on the selected
location.
3.
Be sure that the rear panel has
been fixed firm enough to withstand
the weight of an adult of 60kg,
furthermore, the weight should be
evenly shared by each screw.
Mark on the middle of it
Gradienter
Wall
Space to
the wall
150mm
above
Space to
the wall
150mm
above
Left
Right
(Rear piping hole)
(Rear piping hole)
Install the piping hole
1
．
Make the piping hole
（
φ
55
）
in the wall at a slight downward
slant to the outdoor side. At Fig.6.
2
．
Insert the piping-hole sleeve into the hole to prevent the connection piping
and wiring from being damaged when passing through the hole.
Indoor
Outdoor
Wall pipe
Seal pad
Protection
sleeve pipe
Install the water drainage pipe
1．
2．
3．
For well draining, the drain pipe should be
placed at a downward slant.
Do not wrench or bend the drain pipe or flood
its end by water.
When the long drainage pipe passing through
indoor, wrap it with insulation materials.
Wrenched
Bent
Flooded
Electrical wiring
the terminal on "N", the black one to "2",the brown
Power connection wire
Fig.7
Install indoor unit
Blue
Black
Brown
Yellow-green
1. Open the front panel, to disassemble the screw cap ,
take off the filter,to screw off the screws on the on
front case (4
screws).
5. Install the front case, tighten the screws (4pcs),
install the filter,cover the front panel cover .
2. Put the power connection cable through the back of
indoor unit wire hole and take it out.
one to "3", the yellow-green one (earth wire) to
" " (As shown in Fig. 7)
3. Connect the blue wire of power connection cord to
4. Put the power connection cable the section,
that with
sheath into wire groove, screw on the fixing screw
,
tighten the connection wire.
Wall
Terminal board
6. For the cooling and heating unit, signal control
wire can be passed through the connection of
connector and indoor unit, and use the wire clip
that is under the body case, tighten the signal
control wire (As show in Fig. 8)
Connector
Wire clamp
Signal control
(4X0.75)
Wire in unit
wire
Fig.
8
