Gree GWC09KF-K3DNA5A, Руководство по обслуживанию

Страница: 28 / 88

25
Function and Control
Press TIMER button at unit ON to set TIMER OFF, HOUR OFF blinking. Press TIMER button at unit OFF to set TIMER
ON, HOUR ON blinking. In this case, pr or -
button changes time setting. Holding down either button rapidly
changes time setting (time setting range 0.5-24hours). Press TIMER button again to confirm setting, HOUR O N/OFF
stopping blink. If there is not any
operation of button within 5 seconds during HOUR ON/OFF blinking,
TIMER setting
TIMER: 11
TURBO:
12
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in
shortest time. In COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will
blow strong heating air at super high fan speed. (This function is not applicable for some models).
will be canceled.
SLEEP :
LIGHT:
13
14
Press this button to go into the SLEEP operation mode. Press it again to cancel. This function is available in COOL ,
HEAT (Only for models with heating function) or DRY mode to maintain the most comfortable temperature for you.
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is
tunrned on, is displayed. If the light is tunrned off disappears.
Press "+ " and "-" buttons simultaneously to lock or unlock the keypad. If the remote controller is locked, is displayed.
At unit OFF, press
"
MODE
"
and
" - "
buttons simultaneously to switch between and .
ć ̧
About switch between fahrenheit and cenrigrade
3
About lock :
and
In this case, pressing any button, blinks three times.
2
3
and
2 3
4
3
1.Remove the battery cover plate from the rear of the remote controller. (As shown in the figure).
2.Take out the old batteries.
3.Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
4. Replace the battery cover plate.
Notes:
When replacing the batteries, do not use old or different batteries,
otherwise, it may cause malfunction.
If the wireless remote controller will not be used for a long time,
please remove batteries to prevent damage from leaking batteries.
The operation should be performed in its receiving range.
It should be kept 1m away from the TV set or stereo sound sets.
If the wireless remote controller does not operate normally, please
take the batteries out and replace them after 30 seconds. If still not
operating properly, replace the batteries.
Sketch map for
replacing batteries
6.2 Changing batteries and notices
Press this button to select displaying indoor set temp or indoor ambient temp. Set temp will be displayed after first energization of
indoor unit; When temp display changes to “ ” from other state, the ambient temp will be displayed and then set temp will be
displayed after receiving other remote signals. When turning off the unit, temp display setting will be set temp. If the user has not
set the state of temp display, the set temp will be displayed.