Gree GSA228XA, Руководство пользователя

Страница: 37 / 47

Child lock function
▲
Press "▲" and " " simultaneously to turn on or turn o f f child lock function. When
child lock function is on, " " icon is displayed on remote controlle r . If you operate
the remote controlle r , the " " icon will blink three times without sending signal to the unit.
Temperature display switchover function
Note:
●
Under OFF status, press " " and "MODE
▲
" buttons simultaneously to switch temp-
erature display between
℃
and
℉
.
●
Under 8
℃
heating function, fan speed i s defaulted at auto speed and it can’t be
adjusted.
● Sleep function and 8
℃
heating function can’t operate at the same time. If 8
℃
Under 8
℃
heating function, set temperature can’t be adjusted. Press " TURBO "
button and the remote controller won’t s end signal.
●
heating function has been set under heating mode, press sleep button will cancel
8
℃
heating function. If sleep function has been set under heating mode, start up
the 8
℃
heating function will cancel sle e p function.
8
℃
heating function
Under heating mode, press "TEMP" and "CLOCK" buttons simultaneously to start
up or turn o f f 8
℃
heating function. When this function is started up, " " and "8
℃
"
will be shown on remote controlle r , and the air conditioner keep the heating status
at 8
℃
. Press "TEMP" and "CLOCK" buttons simultaneously again to exit 8
℃
heating function.
Multi timer function
● THREE TIMERS
●
TWO TIMERS
● TIMER CANCELLATION
Function introduction for combination buttons
settings will be erased.
Press uninterruptedly “LIGHT” button 8 times in 5 second s all the “Multi Timer”
Press uninterruptedly “LIGHT” button 4 times in 5 second s thus we enter the “Multi
Timer” mode as well as two-minute-counting-down stars. If two couples of times
commands are valid and well-received in 2 minutes, the “Multi Timer” will be activated
along with the success sound of four bu zz ing, and the former “Multi Timer” settings
with be replaced. If not, then “Multi Timer” mode exits along with the failure sound of
six buzzing, and the former “Multi Timer” s ettings still remain effective.
Interface of dry contact device is provided, while the dry contact device shall be
prepared and installed by the customer.
33
Under
℉
temperature display, the remote controller will display 46
℉
heating.
Dry Contact function
Press uninterruptedly “LIGHT” button 6 times in 5 second s thus we enter the “Multi
Timer” mode as well as three-minute-counting-down stars. If three couples of times
commands are valid and well-received in 3 minutes, the “Multi Timer” will be activated
along with the success sound of four bu zz ing, and the former “Multi Timer” settings
with be replaced. If not, then “Multi Timer” mode exits along with the failure sound
of six buzzing, and the former “Multi Timer” settings still remain effective.
(Not Available)
(Not Available)