44
Maintenance
Service Manual
5. Close the window sash securely against the Window panel.(As show in Fig.19)
6. Stuff the sponge B between the glass and the window to prevent air and insectsfrom getting into the room.(As show in Fig.20)
7. Attach the bracket with a screw.(Recommended)(As show in Fig.21)
Please lay a tabular material underneath the window panel in case you could not attach the rain guard or the window adapter properly
due to the deep window sill.
1.Connect the rain guards to the insect guard net.(As show in Fig.22)
Insert all three projections on each rain guard into the holes in the insect guard net.
Side “A” will now be at the top, as indicated in the diagram.
2.Attach the guard combined above to the window panel. (As show in Fig.23)
+ $ ! #] #
Side “A” will now be at the top, as indicated in the diagram, when it is installed in the window.
3. Cut the foam seal A (adhesive type) to the proper length and attach it to the window frame.(As show in Fig.24)
4. Install the window panel into the window frame.(As show in Fig.25)
Make sure that the exhaust cover is attached to the window panel.
Inner height of the window:20.5"(520mm)
Use the window panel.
The window panel cannot be installed in windows less than 20.5" (520mm) high, as you will be unable to shut the exhaust
cover.(As show in Fig.26)
(1) Open the window sash and place the window panel on the window frame.
(2) Secure the window panel to the window frame with 2 screws.
Fig.19
Fig.20
Fig.21
Fig.22
Fig.24
Fig.25
Fig.26
Fig.23
Bracket
9.4 Installation in a sliding sash window
Hole
Projection
Insect guard net
Rain guard
"A"
Projection
"A"
Window panel
Foam seal A
Cut
Window panel
Exhaust cover
20.5"
