drainage pipe clip
screw
-2
7
-
Installation of drainage hose
2. Remove the rubber plug at drainage port.
1. Fix the drainage pipe clip on the right of rear side plate near drainage port with
a screw.
3. Put the drainage pipe into drainage port and screw it up, and then bind it with
pipe hoop.
■
Instructions for drainage pipe installation.
1. In Cool, Dry or Heat mode operating, the condensation water will be drained to
■
Drainage way as follows.
the chassis.
2. When the chassis is full with water, the buzzer will give out 8 sounds and "H8" is
displayed to remind user to discharge water:
●
Move the unit to a suitable place for discharging water;
do not tilt the unit and keep it horizontal during moving;
●
Take the drainage pipe from the clip and pull out the
rubber plug on the drainage pipe to discharge water;
●
After full water protection is eliminated and the compressor
has been stopped for 3 minutes, the unit will resume operation.
drainage port
drainage port
pipe hoop
pipe hoop
rubber plug
drainage pipe clip
drainage pipe
