9
UNIT OPERATION
IMPORTANT NOTICE :
Do not pierce the bottom of the air conditioner. Excess water is accumulated to cool down the
temperature of the capacitor (outdoor unit). It is normal to hear the capacitor’s blade hit water
accumulated in the bottom of the unit. Not respecting this notice will automatically void the
warranty of the unit.
• Plug the unit into a grounded outlet. Do not use an extension cord nor an adapter plug.
• Press the POWER button to begin operation.
• When turning your air conditioner off, always wait at least 3 minutes before turning it back
on. It will prevent the air conditioner from blowing a fuse or tripping a circuit breaker.
• Do not run your air conditioner in cooling mode when the outdoor temperature is below
18°C (64°F). The internal evaporator will freeze up and the unit will not operate properly.
COOLING MODE
1. Press the MODE button and set to COOL. The indicator light will go on.
2. Press or to set room temperature - 18 to 30°C (64 to 86oF). The set temperature
will show on the LCD display and after 3 seconds, the current room temperature will show
permanently on the display.
3. Press to set fan speed : AUTO, LOW, HIGH or TURBO.
AUTO :
This automatically sets the fan speed to provide an optimum comfort level based on
the set temperature. The fan speed will increase or decrease in order to adjust the
cooling airflow as per the set temperature. This button can be activated only when in
COOL mode. This function cannot be activated in FAN ONLY mode.
LOW :
Fan speed lowest level - for NIGHTIME and/or a SMOOTH cooling.
HIGH :
Fan speed high level - for NORMAL cooling.
TURBO :
High velocity powerful airflow - for a MAXIMUM POWERFUL and FAST cooling.
• For maximum cooling efficiency, draw the curtains or blinds if the room is exposed
to direct sunlight. Do not place near a heat source.
• If the air conditioner is turned off or switched on from FAN ONLY or POWER SAVER mode,
upon turning the unit on to COOL mode, allow a 3 minute delay before the compressor and
cooling operation resume.
FAN ONLY MODE
The FAN ONLY mode provides ventilation and air filtration without cooling. When using the
FAN ONLY mode, the temperature settings cannot be adjusted but the room temperature will
show on the LCD display.
1. Press the MODE button and set to FAN ONLY.
2. Press to set fan speed: LOW, HIGH or TURBO.
NOTE :
The AUTO fan speed cannot be used when in FAN ONLY mode.
