10
UNIT OPERATION
POWER SAVER MODE
Based on set temperature, the fan cycles on and off along with the compressor. This mode
will result in large variations of room temperature and humidity. It is recommended to use
this mode when the room is unoccupied.
1.
Press MODE and set to POWER SAVER (indicator light will go on).
2.
Press or to set room temperature. The set temperature will show on the LCD
display ; after 3 seconds, the current room temperature will appear on the display.
3.
Press to set fan speed : AUTO, LOW, HIGH or TURBO ; each speed indicator light will
go on when selected.
NOTE :
The fan and the compressor may not cycle on and off simultaneously.
SETTING THE TIMER
The timer is used to set an automatic start or shut off.
Automatic start :
1.
Press TIMER when the unit is OFF ; the timer indicator light will flash.
2.
Press or to set the numbers of hours (1-24) before the turn on.
3.
The LCD display shows the time (in hours) left before the unit starts.
4.
Presss TIMER again or wait 10 seconds, the indicator light will stay on.
Automatic shut off :
1.
Press TIMER when the unit is ON ; the timer indicator light will flash.
2.
Press or to set the numbers of hours (1-24) before the shut off.
3.
The LCD display shows the time (in hours) left before the unit turns off.
4.
Press TIMER again or wait 10 seconds, the indicator light will stay on.
To cancel the timer :
The air conditioner can be either on or off to clear the timer ; simply press and hold the
TIMER button for 3 seconds, until the indicator light goes off.
Showing the time left (number of hours) :
1.
Press on TIMER after it has been programmed.
2.
While the display shows the time left before the start or shut off of the air conditioner,
press or if you want to change the number of hours.
FILTER CLEANING WARNING LIGHT
1.
When the FILTER light is on, it indicates that the air filter is dirty. Remove and clean the
air filter or replace it. Refer to “Cleaning the air filter” (p. 13).
2.
Put the filter back in place.
3.
To reset, press and hold the FILTER button for 5 seconds - pilot light will go off.
