11
CHOOSE
PRESS
MODE BUTTON
FAN ONLY
THE TIME CHOSEN:
FIRST DO THIS:
PRESS TIMER BUTTON
Note: Use this function only when cooling is not desired, such as for room air circulation. You can choose any fan speed you prefer,
EXCEPT AUTO FAN.During this function, the display will show the actual current temperature, not the set temperature as in the cooling mode
A
PRESS TEMP/TIMER
BUTTON
TIMER-DELA
START/ST
COOL
FEA
models)
PRESS
MODE BUTTON
SELECT COOL
Note This feature can be used with any combination of FAN Speeds, Timer .When in the Cooling Mode, the fan will run continuously
Note 1: For Delay Stop, the unit must be in the ON position.
Note 2: For Delay Start, the unit must be in the OFF position.
To adjust timer setting, tap or hold the UP arrow (^) or DOWN arrow (v) to change the delay time by 0.5 hour increments up to 10 hours,
then by 1 hour increments up to 24 hours. The control will count down the timer remaining until start (8, 7.5, 7, etc.). After
set Timer,the unit will enter into Timer mode by 5 seconds, then Timer light on, Set light off. In Timer mode: Set temperature
and fan speed keeps previously set temperature and fan speed; Temperature display set temperature, no display if power
turn off; Press Timer once, LED display remaining time of set time, LED return to set temperature by 5 seconds;
When in Fan Only mode, LED only display room temperature, do not display set temperature.Turning the unit "ON" or
"OFF" at any timer will cancel the Delay Start/Stop function. The delay Start/Stop feature will work until the unit either starts
or stops. Once this has happened then the above steps have to be repeated again.
:
:
RESET
FILTER
N
RESET
N
FILTER
RESET
N
FILTER
RESET
FILTER
N
RESET
FILTER
N
TO OPERATURE ON FAN ONLY:
AIR CONDITIONER FEATURES
(continued)
:
while cool is needed. The temperature will automatically be maintained anywhere between 61°F (16°C) and 86°F (30°C). When the room
set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air. If the air conditioner is off and is then turned
on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately 3 minutes for the compressor to
start and cooling to begin.
